Quick Answer: This braided nylon cord is a 25 m length of cord made from nylon strands woven into a braid. In the physics lab the braided nylon cord is cut into lines for pulleys, pendulums, force tables and hanging masses, where a smooth, strong cord that does not twist is wanted.
Why Braided Rather Than Twisted
Ordinary string is made by twisting strands together, and under load it tries to untwist. A hanging mass on twisted string slowly turns, and a pendulum bob can rotate as it swings. A braid interlaces its strands in opposite directions, so their twisting tendencies balance and a load hangs without spinning.
Nylon adds a smooth surface that runs easily in a pulley groove and good strength for its thickness. It is slightly elastic, which makes no practical difference in an Atwood machine or on a force table, but it does mean a pendulum’s length should be measured with the bob attached and hanging.
Cutting, Knotting and Sealing
Cut nylon frays quickly unless its ends are sealed. Briefly melting each cut end in a match flame or with a hot knife fuses the fibres, a job for the teacher or technician away from anything flammable; wrapping the end in tape is a cold alternative. Because nylon is slippery, choose knots that lock: a bowline for a loop to hang masses from, a double overhand knot as a stopper, and test every knot with a pull before loading it.
At 25 m the cord cuts into twenty-five 1 m lines, enough for a class set of pulley or pendulum stations with some left over.
Specifications
| Product | Braided nylon cord |
| Length | 25 m, from the title |
| Construction | Nylon strands braided together |
| Typical uses | Pulley lines, pendulum threads, hanging masses, force tables |
| Diameter and breaking load | Confirm at enquiry |
Applications
- Lines over pulleys for Atwood machines and trolley experiments
- Pendulum threads where the bob must not spin
- Hanging slotted masses and force-table strings
- Tying apparatus together during set-up
Care & Handling
- Store the roll dry and out of direct sunlight, which weakens nylon over time
- Seal or tape cut ends straight away
- Check lines for wear where they run over pulleys and replace frayed lengths
- Keep the cord away from hot plates and flames, except when an end is briefly sealed under supervision
Why Choose LabEquip
Physics teachers keep braided nylon cord for the jobs where ordinary string lets them down: pulleys, where it must run smoothly, and pendulums, where the bob must not spin. Use it with the pulley on rod, or choose the roll of twine for general tying; contact LabEquip for quantities, or browse physics lab equipment.
Frequently Asked Questions
Why does braided cord not make a hanging mass spin?
A braid interlaces strands in opposite directions, so their twisting tendencies cancel. Twisted string, by contrast, tries to unwind under load and slowly turns whatever hangs from it.
How do I stop the cut ends fraying?
Melt each cut end briefly with a match flame or a hot knife so the nylon fibres fuse, working under supervision and away from anything flammable. Wrapping the end in tape is a cold alternative.
Which knots hold in nylon cord?
Nylon is smooth, so simple knots can slip. A bowline makes a secure loop for hanging masses, a double overhand knot serves as a stopper, and every knot should be pulled tight and tested before loading.
Does nylon cord stretch?
Slightly, because nylon is somewhat elastic. The stretch is negligible in most pulley and force experiments, but for a pendulum the length should be measured with the bob attached.
How many pulley lines does 25 m make?
Cut into 1 m lengths it gives twenty-five lines, enough for a class set of pulley or pendulum stations with some to spare.
How thick and strong is the cord?
The diameter and breaking load are not stated in the listing and can be confirmed at enquiry. Match the cord to your pulley grooves so that it runs freely without jumping out.
Last Updated: October 2026










Reviews
There are no reviews yet.