Search

In Stock

Elevating grid for water bath

$15.23

Quick Answer: The Elevating grid for water bath is a stainless steel platform that stands on the tank floor and lifts flasks, bottles and racks higher in the water, pictured carrying conical flasks of two sizes, so that small vessels sit at the right depth while the bath stays filled to its working level.

Matching Vessel Depth to Water Depth

A water bath works well when the bath water reaches roughly the same height as the liquid inside each vessel. With a deep tank and small flasks, that rule causes a problem: lowering the water to suit the flasks can take it below the bath’s minimum fill mark, while filling the bath properly leaves the flasks bobbing or submerged to the neck. An elevating grid solves it by bringing the vessels up instead of bringing the water down.

The photo shows two loaded platforms, one with a group of small conical flasks and the other with a few larger ones, each standing on folded legs above the floor. The image file links the grid to Memmert WTB15 and WTB24 baths, which indicates the tank sizes it was made for. Flasks stand freely on the platform, so it suits static incubation rather than shaking.

Platform height is the main decision when choosing. Related items include the WTB raising grid, listed by tank-bottom height, and the elevating grid for the WNB-7L bath for a much smaller tank.

Typical Uses

  • Warming small conical flasks of culture media without bath water reaching their necks
  • Raising bottles so that caps and labels stay dry above the water line
  • Lifting tube racks so short tubes sit at the right depth in a deep tank
  • Keeping vessels clear of sediment or scale on the tank floor

Specifications

Material Stainless steel, as pictured
Form Flat platform on folded legs, as pictured
Position Stands on the tank floor
Purpose Raises vessels so they sit at the right depth in a full bath
Bath models Image file refers to Memmert WTB15 and WTB24
Platform height and footprint Confirm at enquiry

Care & Handling

  • Place the grid level on the tank floor before filling, and check that it does not rock.
  • Spread flasks evenly so the platform takes the weight squarely.
  • Take the grid out during descaling and rinse both grid and tank.
  • Dry the grid after use to stop water spots and scale forming on the platform.

Why Choose LabEquip

Labs that use a deep water bath for small vessels buy an elevating grid instead of running the bath half empty. LabEquip lists it in General Lab Products; send your bath model and vessel sizes through the contact page so the right height can be chosen.

Frequently Asked Questions

Why not just lower the water level?

Every water bath has a minimum fill level that keeps its heater covered. Raising the vessels lets small flasks sit at the right depth while the bath stays above that level.

How high should the water come on a flask?

Roughly level with the liquid inside it. Much lower and the top of the liquid warms slowly; much higher and the flask may float or water may reach the neck.

Can flasks be shaken on this grid?

No. Flasks simply stand on the platform, so it is meant for static incubation. Shaking needs clamps or racks fixed to a moving frame.

Which baths does the grid fit?

The image file names Memmert WTB15 and WTB24 baths. Measure the floor of your tank and compare it with the grid’s footprint before ordering.

Will light flasks float off the grid?

Empty or nearly empty flasks can lift as the water rises around them. Fill them first, or hold them down with weighted flask rings.

Is stainless steel affected by long use in warm water?

It does not rust in normal use, but hard-water scale and chloride-rich spills can mark it. Rinse the grid, dry it and descale it at the same time as the tank.

Last Updated: October 2026

Reviews

There are no reviews yet.

Write a review

Back to Top
Select your currency
USD United States (US) dollar
Product has been added to your cart
Compare (0)