Quick Answer: The Sauter 283 dynamometer is a compact mechanical spring force meter in which a calibrated spring stretches inside a tubular body and an indicator shows the force on a scale. The Sauter 283 dynamometer is used in the laboratory to measure weights, pulling forces, friction and upthrust.
A Spring Turned into a Scale
Inside the Sauter 283 dynamometer, the extension of the spring is proportional to the force on the hook, as Hooke’s law describes. The scale is marked so that each division corresponds to a fixed force, and the instrument is only accurate while the spring stays within its elastic range. Loading beyond the top of the scale can stretch the spring permanently and shift every later reading.
Before each use, hold the instrument in the orientation in which it will be used and set the zero. Held vertically, the hook and spring carry part of their own weight; held horizontally, they do not, so the zero position differs. Zeroing in the working position removes that error.
Choosing and Checking the Range
Spring force meters of this type are made in a series of capacities, so the model should be chosen to suit the experiment. A good rule is that the expected forces should fall in the upper half of the scale, where the relative reading error is smallest.
A quick check uses known masses: a 100 g mass should read about 0.98 N, and doubling the mass should double the reading. If the readings are consistently high or low, the zero or the spring needs attention before the class relies on it.
Measurements
- Weighing objects in newtons and comparing weight with mass
- Measuring sliding friction by pulling a block at a steady speed
- Finding upthrust by weighing an object in air and then in water
- Measuring the force along an inclined plane
Specifications
| Product | Mechanical spring dynamometer (force meter) |
| Series | Sauter 283, as titled |
| Operating principle | Spring extension proportional to force |
| Adjustment | Zero set in the working orientation before use |
| Capacity and scale division of the supplied model | Confirm at enquiry |
Care & Handling
- Never load beyond the end of the scale, and never let a stretched spring snap back
- Pull along the axis of the instrument; side loads cause friction and wrong readings
- Check the zero before each session and after the instrument has been dropped
- Store unloaded in a dry place so the spring and mechanism do not corrode
Why Choose LabEquip
Schools and college labs choose the Sauter 283 dynamometer when they want a compact mechanical force meter that students can carry between experiments. LabEquip can advise on the capacity your practicals need and supply it with masses marked in newtons for checking it and other physics lab equipment; request the capacities you need from LabEquip.
Frequently Asked Questions
Why does the zero change when the dynamometer is held sideways?
When the instrument hangs vertically, the hook and the lower part of the spring pull on the spring under their own weight. Held horizontally they do not, so the zero shifts. Always zero it in the position you will measure in.
How can the reading be checked?
Hang known masses from the hook. A 100 g mass weighs about 0.98 N and a 200 g mass about 1.96 N, so the readings should increase in proportion to the mass.
How is sliding friction measured with it?
Attach the dynamometer to a block on the bench, keep the instrument horizontal and pull so the block slides at a steady speed. The reading then equals the sliding friction force.
How is upthrust found?
Weigh the object hanging in air, then lower it fully into water and read again. The difference between the two readings is the upthrust, which equals the weight of water displaced.
Which capacity should be chosen?
Pick one where the forces in your experiment fall in the upper half of the scale. A low-capacity model gives finer readings for light loads but is easily overloaded by heavier ones.
What damages a spring dynamometer?
Overloading past the end of the scale, letting the hook snap back after a pull, pulling at an angle to the body and storing it with a load on the hook. Each can distort the spring and spoil the calibration.
Last Updated: October 2026










Reviews
There are no reviews yet.