Quick Answer: The moments disc is a flat disc that turns on a low-friction pivot at its centre and is held on a steel board by a magnetic mount. Forces are applied to the moments disc at points at different distances from the centre and in different directions, to investigate the law of moments.
Turning Effect and the Perpendicular Distance
On a straight beam, loads usually hang straight down and the distance along the beam is the lever arm. The moments disc lets forces act in any direction in the plane of the board, using strings over pulleys or force meters pulling at an angle. That reveals the full rule: the moment of a force about the pivot equals the force multiplied by the perpendicular distance from the pivot to the line of action of the force.
For example, a string attached 10 cm from the centre but pulling at 30 degrees to the radius has a lever arm of only 10 × sin 30° = 5 cm. Students can draw the string line on the board, drop a perpendicular from the pivot to it and measure that 5 cm directly.
Balancing the Disc
The moments disc is in equilibrium when the sum of the clockwise moments equals the sum of the anticlockwise moments about the pivot. Because the pivot also pushes on the disc, the forces themselves need not cancel; only their moments must. The disc’s own weight acts through the pivot and so contributes no moment.
A couple shows the opposite case. Two equal forces in opposite directions on parallel lines either side of the centre give no net force but a turning effect equal to one force times the distance between the lines, and the disc rotates without being pushed sideways.
Specifications
| Product | Disc for the principle of moments |
| Pivot | Central low-friction axis |
| Mounting | Magnetic, for vertical steel boards |
| Load points | Attachment holes at different distances from the centre |
| Disc diameter and hole layout | Confirm at enquiry |
Investigations
- Verifying the law of moments with forces at different radii
- Showing that only the perpendicular distance to the line of action matters
- Demonstrating a couple and its turning effect
- Finding an unknown force from a balanced arrangement
Care & Handling
- Keep the pivot free of dust and never oil it unless the instructions say so
- Check the disc turns freely and stays put in any position before loading
- Attach and remove loads with the disc held, so it cannot spin and fling a mass
- Store the disc flat, with the magnet protected from steel filings
Why Choose LabEquip
Teachers who want to go beyond the metre-rule balance choose the moments disc, because angled forces make the idea of a lever arm concrete. LabEquip pairs it with the lever balance on magnetic support and other physics lab equipment for board-based statics; contact LabEquip to plan a set.
Frequently Asked Questions
Is this a magnetic moment experiment?
No. It studies the moments, or turning effects, of forces. The magnet only holds the disc on a steel board; it plays no part in the physics being measured.
Why is a disc used instead of a straight beam?
A disc can take forces from any direction around the pivot, so students can see the effect of angle. A beam is mostly limited to parallel forces at right angles to it.
How is the lever arm of an angled force measured?
Mark the line of the string on the board, then measure the shortest distance from the pivot to that line, which meets it at right angles. Alternatively, multiply the distance to the attachment point by the sine of the angle between string and radius.
What is a couple?
Two equal and opposite forces acting along parallel lines that do not coincide. They cancel as forces but produce a turning effect equal to one force times the distance between their lines.
Why does the disc need a low-friction pivot?
Friction at the pivot can hold the disc still even when the moments do not quite balance, hiding small differences. A free pivot makes the disc respond to an imbalance of a few percent.
How is the disc checked before forces are added?
With no loads attached, turn it to several positions and let go. If it stays wherever it is left, its centre of gravity is at the pivot and its weight will not affect the results.
Last Updated: October 2026










Reviews
There are no reviews yet.