Search

In Stock

CIRCULAR COIL FOR DEMONSTRATING FIELD LINES

Uniform Winding on Transparent Base: Allows clear observation of magnetic field interactions and pattern formation.

Stable Mounting with Current Input Terminals: Ensures consistent positioning and safe electrical connections during experiments.

₹165.00

Quick Answer: The Circular Coil for Demonstrating Field Lines is a loop of wire arranged so that its magnetic field can be made visible on a flat surface crossing the coil, normally a horizontal board through which the coil passes. Sprinkled iron filings or small compasses reveal the circular coil field lines when a current flows.

Making the Pattern Visible

The coil passes up through the board at two points on opposite sides of the circle. With the supply switched on, iron filings are sprinkled thinly on the board and the board is tapped gently, letting each filing turn and line up with the local field. Close to each wire the filings form small concentric rings, just as around a single straight conductor. Towards the middle of the loop the rings stretch out and the lines run almost straight and parallel through the centre.

Placing plotting compasses on the board shows the direction of the lines: they circle the two wires in opposite senses, because the current goes up through the board on one side and down on the other. The right-hand grip rule predicts that sense, and reversing the supply leads makes every compass needle swing round. The pattern on one side of the loop looks like the field of a short bar magnet, with one face of the coil acting as a north pole and the other as a south pole.

What Students Learn From It

  • Seeing the field of a current loop and comparing it with a straight wire and a solenoid
  • Applying the right-hand grip rule to predict field direction at the centre
  • Showing that reversing the current reverses the field
  • Relating the loop to a magnetic dipole and to the coils in motors and loudspeakers

Specifications

Apparatus Circular coil for field-pattern demonstration
Viewing surface Usually a flat board crossing the plane of the coil
Pattern revealed with Iron filings and plotting compasses
Supply Low-voltage DC, switched on only for the demonstration
Turns, coil diameter and board material Confirm at enquiry

Getting a Clear Pattern

A single loop carrying a few amperes produces a field only a little stronger than the Earth’s near the wires, so the pattern is clearest from a coil with several turns and a supply that can deliver a fairly large current for a short time. Fine, dry filings shaken from a pepper-pot dispenser spread evenly, whereas clumps from damp filings hide the pattern. For a permanent record, students can lay a sheet of paper on the board before sprinkling and photograph it, or trace the lines with a plotting compass step by step.

Care & Handling

  • Switch the current off as soon as the pattern has formed; a coil carrying a large current warms quickly.
  • Tip filings back into their container over a sheet of paper and keep them dry so they do not rust and clump.
  • Keep filings away from the terminals and the supply, where they can bridge connections.
  • Wipe the board with a dry cloth; a magnet wrapped in a plastic bag lifts stray filings.

Why Choose LabEquip

Schools usually buy this coil as part of a set with straight-wire and solenoid demonstrators so that all three field patterns can be compared in one lesson. It is listed in LabEquip’s Physics Equipments range, and the compass for drawing magnetic field suits the direction-mapping step. Use our contact page for quantities.

Frequently Asked Questions

Why do the filings form circles near the wire?

Each section of wire passing through the board carries current like a short straight conductor, and the magnetic field around a straight current is a set of concentric circles. The filings line up along those circles.

Why is the field at the centre of the loop straight?

Each side of the loop contributes a field at the centre, and both point the same way along the coil’s axis. Their sum is a fairly uniform field there, so the lines run nearly straight and parallel.

How can I tell which face of the coil acts as the north pole?

Look at the face of the coil: if the current flows anticlockwise as you look, that face is a north pole; if clockwise, it is a south pole. A plotting compass placed near the face confirms it.

Why is the pattern faint with a small current?

The coil’s field must be strong compared with the Earth’s field and with friction between the filings and the board. More turns, a larger current for a short time and gentle tapping make the pattern sharper.

Can I use this coil to measure field strength?

Not directly. It is designed to show the shape and direction of the field. For measurements along the axis, a circular coil used with a deflection magnetometer, or a calibrated magnetic field sensor, is needed.

Is it safe for students to use?

It runs from a low-voltage supply, so the main risks are a hot coil and hot leads if the current is left on. Keep switching times short, use leads rated for the current, and keep iron filings away from eyes.

Last Updated: October 2026

Reviews

There are no reviews yet.

Write a review

Back to Top
Select your currency
INR Indian rupee
Product has been added to your cart
Compare (0)