Quick Answer: The Support and cover for dry bath is pictured as a clear rectangular cover whose top is drilled with rows of holes: it closes over a dry-bath block like a lid, while tubes taller than the cover pass through the holes and are held upright.
Two Jobs in One Part
Taller tubes are awkward in a dry bath. Their lower part sits in the block, but the upper part sticks out above any plain lid, so the lid cannot close and the tubes are free to lean. The support and cover for dry bath handles both problems: its top plate has rows of holes that line up with the block, so each tube passes through a hole and is steadied at two heights.
The cover walls around the block still trap warm air, which keeps the part of each tube just above the block warmer than it would be in the open. Because the cover is clear, sample levels and labels stay visible, and you can see at a glance which positions are in use.
Hole spacing has to match the block below, otherwise tubes are forced at an angle. The block format, hole size and cover material are not given in the title. For short tubes that fit fully underneath, a plain cover for tube block is the simpler choice.
Applications
- Heating taller screw-cap tubes in a dry bath without them leaning
- Long incubations of tubes that stand above a plain lid
- Keeping tube labels visible and in order on a block
- Reducing heat loss from the upper part of tall tubes
Specifications
| Type | Combined tube support and cover for dry baths |
| Appearance | Clear rectangular cover with rows of holes in the top, as pictured |
| Function | Steadies tall tubes and covers the block |
| Alignment | Holes must line up with the block wells |
| Block format and hole size | Confirm at enquiry |
Care & Handling
- Lift the support and cover for dry bath straight up so the tubes do not catch on the holes.
- Wash it with mild detergent and water, avoiding solvents that can damage clear plastics.
- Find out the material’s heat limit before using it on a block set at a high temperature.
- Keep it flat in storage so the hole pattern stays aligned with the block.
Why Choose LabEquip
Labs that heat taller tubes in block heaters need a part that steadies them as well as covering them. LabEquip lists dry baths such as the Digital dry bath for microtubes and block accessories in General Lab Products; ask about block formats through the contact page.
Frequently Asked Questions
Why does a tall tube need support in a dry bath?
Only the lower part of the tube sits in the block, so a tall tube can lean, touch its neighbour or tip if knocked. A second support point near the top keeps it vertical.
How is this different from a plain block cover?
A plain cover fits only over tubes shorter than itself. This one has holes in its top, so tall tubes pass through and are held while the block stays covered.
Do the holes have to match my block?
Yes. The holes should sit directly over the wells; if the spacing differs, tubes are pushed at an angle and may not seat fully.
Does it keep heat in as well as a closed lid?
Some warm air escapes around the tubes through the holes, so it holds a little less heat than a solid lid. It still shields the block and the lower tubes from room air.
Can it be used on a cooled block?
Yes. On a chilled block it slows warming from the room and steadies the tubes, though some condensation may form underneath.
How should the cover be cleaned?
Wash it in warm water with mild detergent, rinse and air dry. Avoid acetone and abrasive pads, which mark clear plastics.
Last Updated: October 2026










Reviews
There are no reviews yet.