Quick Answer: The Agitation Device for Water Bath is an add-on shaking unit, pictured as a stainless steel motor housing with a small display that mounts on the back edge of a bath and moves a rectangular frame to and fro inside the tank, so racks and flasks fixed to the frame are shaken while held at temperature.
Turning a Static Bath into a Shaking Bath
In lab English, agitation simply means shaking or stirring. A plain water bath holds samples at a set temperature but leaves them still, so cells settle, gases exchange slowly and viscous mixtures mix poorly. An agitation device adds movement without replacing the bath: the housing sits on the rear wall of the tank, and the frame that reaches from it into the water carries the samples back and forth.
The frame is the mounting point for everything that moves. Test tube racks made for the shaking system, such as the rack for the WTB shaking system, and flask clamps such as the tulip flask clamp fix onto it. The image file for this listing refers to Memmert WTB35 and WTB50 baths, which points to the tank sizes the unit is made for.
Speed is chosen for the job: gentle movement for cell cultures and protein solutions that must not foam, faster movement for extractions or for dissolving solids. The display on the housing is where the unit’s setting is shown.
What Shaking in a Bath Is Used For
- Growing bacterial or yeast cultures in flasks at a set temperature with better aeration
- Enzyme digestions and other incubations where contents must stay mixed
- Extractions of soil, food or plant samples into a liquid at controlled temperature
- Dissolving slow-to-dissolve solids in warm liquid
Specifications
| Type | Add-on shaking (agitation) unit for a water bath |
| Mounting | Housing on the rear edge of the tank, as pictured |
| Moving part | Rectangular frame that travels inside the tank |
| Controls | Stainless housing with a small digital display, as pictured |
| Accessories that fit the frame | Shaking-system racks and flask clamps |
| Compatible bath models | Confirm at enquiry |
Care & Handling
- Keep the motor housing dry: fill and empty the bath with the unit switched off, and wipe splashes promptly.
- Load the frame evenly and fix racks and clamps firmly before starting, as loose items rattle and wear the drive.
- Start at a low speed and increase gradually, checking that no flask throws liquid over its rim.
- Keep the water level below the housing and clear of the drive.
Why Choose LabEquip
Microbiology, biochemistry and food labs that own a suitable Memmert water bath buy this unit to add shaking without buying a separate shaking bath. LabEquip lists it in General Lab Products; send your bath model through the contact page.
Frequently Asked Questions
What does agitation mean here?
Agitation means shaking. The device moves a frame back and forth inside the bath, so samples on the frame mix continuously while the bath holds their temperature.
Do I need a new water bath to use it?
No. It is an add-on that mounts on a suitable existing bath. The bath’s own heater and controller keep regulating the temperature.
What holds the samples on the moving frame?
Racks and flask clamps made for the shaking system fix onto the frame. Loose racks or bottles should never be placed on it, because they would slide or tip.
Why shake cultures while they incubate?
Shaking keeps cells suspended and draws air into the liquid, so aerobic cultures grow more evenly. It also keeps the temperature uniform throughout each flask.
What speed should be used?
Start slowly and increase until the liquid moves well without splashing. Delicate cells and protein solutions that foam need gentle settings; extractions tolerate faster ones.
Which baths does it fit?
The image file for this item refers to Memmert WTB35 and WTB50 baths. Tank sizes differ, so confirm your bath model at enquiry before ordering.
Last Updated: October 2026










Reviews
There are no reviews yet.