Quick Answer: The Rheostat, Constantan (Eureka) Wire is a variable resistor made of constantan resistance wire wound on an insulating former, with a sliding contact that changes how much wire is in circuit. A constantan rheostat controls current or divides voltage in physics practicals, and its low temperature coefficient keeps the resistance steady as it warms.
Why Constantan Suits a Rheostat
A rheostat works by length. The sliding contact picks off part of a long winding, and the resistance in circuit is proportional to the length of wire between the end terminal and the slider. Connected by two terminals it is a variable series resistance that sets the current; connected by all three it becomes a potential divider giving a variable voltage from a fixed supply.
Constantan, also sold as Eureka wire, is a copper-nickel alloy whose resistance changes very little with temperature. That matters because a rheostat’s wire inevitably warms as it carries current. With constantan, the setting that gave a certain current at the start of a reading still gives almost the same current a minute later, which is valuable where a current must hold steady, as in a potentiometer driver circuit.
The alternative in this range is the groove type nichrome rheostat. Nichrome has a higher resistivity and tolerates higher wire temperatures, so it suits heavier loads; constantan suits circuits where a stable setting matters more. The resistance and current rating of this rheostat are not given in the listing title.
Specifications
| Type | Sliding-contact rheostat |
| Resistance wire | Constantan (Eureka) alloy, as titled |
| Key property | Very low temperature coefficient of resistance |
| Connections | Two-terminal variable resistor or three-terminal potential divider |
| Resistance and current rating | Confirm at enquiry |
Applications
- Setting a steady driver current in potentiometer experiments
- Varying the current in Ohm’s law and I-V characteristic practicals
- Using the rheostat as a potential divider to supply a variable voltage
- Calibrating an ammeter or voltmeter against a standard
Care & Handling
- Start with the slider at maximum resistance and reduce it gradually.
- Stay within the current rating; an overloaded winding becomes too hot to touch.
- Keep the slider track clean and dry, and do not oil the wire.
- Let the winding cool before handling after heavy use.
Why Choose LabEquip
Physics laboratories buy constantan rheostats for practicals where a current must stay put once set, especially potentiometer and calibration work. LabEquip lists this rheostat in Physics Equipments; confirm the resistance and current rating you need through the contact page.
Frequently Asked Questions
What is Eureka wire?
Eureka is a trade name for constantan, a copper-nickel alloy. It is used as resistance wire because its resistivity is fairly high and its resistance changes very little with temperature.
When should a constantan rheostat be chosen over nichrome?
When the current must stay steady as the wire warms, as in a potentiometer driver circuit or an instrument calibration. Nichrome is preferred when a high resistance in a short length or a high operating temperature matters more.
How is a rheostat connected as a potential divider?
Connect the supply across the two end terminals and take the output between one end terminal and the slider. Moving the slider varies the output smoothly from zero to nearly the full supply voltage.
Why should the slider start at maximum resistance?
With the full winding in circuit the first current is small, which protects meters, lamps and the rheostat itself. Then reduce the resistance gradually to reach the current required.
Why does the rheostat get warm?
All resistance wire turns some electrical energy into heat, at a rate equal to current squared times resistance. Constantan keeps its resistance almost unchanged as it warms, but it must still be used within its current rating.
How do I clean a rheostat that gives jumpy readings?
Switch off, then wipe the slider track and the contact with a clean, dry cloth. Oxide or dust between the slider and wire causes erratic contact resistance. Do not oil the wire, because oil attracts dirt.
Last Updated: October 2026










Reviews
There are no reviews yet.