Quick Answer: A radiometer, often called a light mill or Crookes radiometer, is a sealed glass bulb with most of its air pumped out, holding light vanes balanced on a fine pivot, with one face of every vane blackened and the other left bright. When light or infrared radiation falls on the radiometer light mill, the rotor starts to turn, converting the absorbed energy into movement you can see.
Why the Vanes Turn
The dark faces absorb more of the incoming radiation than the bright faces, so they become slightly warmer. The few gas molecules left in the bulb that strike or flow past a warm dark face leave with a little more energy than those at the cooler bright face, and the effect is strongest around the edges of the vanes. The result is a small net push on the dark sides, so the rotor turns with its blackened faces retreating from the lamp.
The direction of rotation is itself a lesson. If light pressure were the cause, the bright faces, which reflect light and so receive twice the momentum, would be pushed harder and the mill would turn the other way. The observed direction shows that a thermal effect in the remaining gas, not the pressure of light, drives the mill. With too much air the drag stops it, and in a near-perfect vacuum there is no gas to push, so a partial vacuum is essential.
Using the Radiometer in Class
Placed in sunlight or near a lamp, the mill starts within seconds, and moving the lamp closer makes it spin faster. Holding a sheet of glass or clear plastic between a lamp and the bulb, then a sheet of black card, lets students compare how much radiation passes through each, and a warm hand or a hot object brought close can start the vanes even in a dim room.
Specifications
| Product | Radiometer (light mill) |
| Construction | Sealed, part-evacuated glass bulb with vanes on a needle pivot |
| Vanes | One face dark, one face bright on each vane |
| Driven by | Visible light and infrared radiation |
| Power | None; runs on absorbed radiation |
| Bulb size and base type | Confirm at enquiry |
Demonstrations
- Showing that radiation carries energy that can be converted into motion
- Comparing absorption by dark and bright surfaces
- Showing qualitatively how intensity falls with distance from a lamp
- Discussing why the direction of spin rules out light pressure as the cause
Care & Handling
- Handle the bulb by its base; the glass is thin and holds a partial vacuum
- Do not heat the bulb directly with a flame or hot plate
- Keep it out of strong direct sun when not in use so the vanes are not run constantly
- Store it upright and padded so the needle pivot is protected
Why Choose LabEquip
Physics teachers keep a radiometer because it turns the idea of radiation as energy into something students can see. LabEquip also lists the Crookes radiometer in its STEM range and supplies a full line of physics lab equipment; contact LabEquip to confirm which version suits your lessons.
Frequently Asked Questions
In which direction does the rotor spin?
The blackened faces retreat from the light source while the bright faces lead the way round.
Does light pressure make the mill turn?
No. If it did, the bright, reflecting faces would be pushed harder and the rotation would be reversed. The motion comes from the warmer dark faces acting on the thin gas left in the bulb.
Why is the bulb only partly evacuated?
Some gas is needed to push on the warm faces, but too much gas creates drag. Only at low pressure is the push larger than the drag, so the vanes spin.
Does it work with a torch or an LED lamp?
It responds to any source that delivers enough energy to the vanes. Sources rich in infrared, such as sunlight and filament lamps, usually drive it most strongly.
What happens if the bulb is cooled?
If the bulb is cooled after warming, the vanes can briefly spin the other way, because the dark faces now lose heat faster than the bright faces.
Can the radiometer be repaired if the glass cracks?
No. Once the seal is broken, air enters and the mill stops working, so the bulb must be handled with care.
Last Updated: October 2026










Reviews
There are no reviews yet.