Quick Answer: Neodymium Discs are small, flat disc magnets made of neodymium-iron-boron (NdFeB), the strongest common permanent magnet material, with their poles usually on the two flat faces. Neodymium disc magnets give a strong field from a very small magnet, which makes possible demonstrations such as the homopolar motor.
Strong Field from a Small Disc
Neodymium-iron-boron magnets produce a much stronger field than ferrite or Alnico magnets of the same size. A disc no bigger than a coin can hold a heavy steel object, and its field reaches far enough to act through a hand or a book. The material is metallic, brittle and prone to corrosion, so the discs are usually given a thin metal plating, commonly nickel.
The great strength has a cost in care. Two neodymium discs allowed to fly together can pinch skin painfully and may chip or shatter, throwing sharp fragments, so eye protection is sensible when several are handled. The material also loses its magnetism permanently if heated above a fairly modest temperature for standard grades, below the boiling point of water, so the discs must be kept away from flames and hot plates.
The Homopolar Motor
The neatest demonstration with neodymium discs is the homopolar motor. A disc magnet is placed under the negative terminal of a dry cell, and a bent piece of bare copper wire is balanced on the positive terminal so that its ends brush the edge of the magnet. Current flows down the wire, through the conducting plating of the magnet and back to the cell, and the force on the current in the magnet field spins the wire.
The motor makes the force on a current visible in a few seconds and invites good questions about direction: turning the magnet over or reversing the cell reverses the spin. Because the circuit is almost a short circuit, the cell and wire get warm, so the motor should run only for short periods.
Demonstrations with Neodymium Discs
- Building a homopolar motor with a dry cell and copper wire
- Showing that magnetic force acts through hands, card, wood and water
- Slowing a disc sliding down a thick aluminium or copper plate by eddy currents
- Holding work to steel boards and as strong poles for field-line demonstrations
Specifications
| Type | Disc-shaped permanent magnets |
| Material | Neodymium-iron-boron (NdFeB), usually plated |
| Poles | Usually on the two flat faces |
| Main feature | Very strong field for the size of the magnet |
| Diameter, thickness, grade and coating | Confirm at enquiry |
Care & Handling
- Separate discs by sliding them sideways; never let them snap together.
- Keep them well away from young children; swallowed magnets can cause serious internal injury.
- Keep them away from pacemakers, bank cards, phones and hard drives.
- Do not heat, cut or drill neodymium magnets; heat destroys their magnetism.
Why Choose LabEquip
Physics teachers buy neodymium discs for short, memorable demonstrations where a small, very strong magnet is needed. For pole testing and class sets, the gentler ferrite discs are often bought alongside, and both are listed in LabEquip’s physics equipment category. For grades, sizes and quantities, use the contact page.
Frequently Asked Questions
How strong are neodymium disc magnets compared with ferrite?
Neodymium-iron-boron magnets are several times stronger than ferrite magnets of the same size. A small neodymium disc can do the work of a much larger ferrite or Alnico magnet.
How do I make a homopolar motor with a neodymium disc?
Stand a dry cell on the disc magnet, then balance a bent piece of bare copper wire on the top terminal so its lower ends touch the side of the magnet. The wire spins; run it only briefly because the cell heats up.
Why are neodymium magnets plated?
The alloy contains a lot of iron and corrodes easily, especially in damp air. A thin metal plating, commonly nickel, protects it; once the plating is chipped, the magnet can start to crumble.
Can heat damage neodymium discs?
Yes. Standard grades begin to lose their magnetism permanently at temperatures below the boiling point of water, and the loss is not recovered on cooling. Keep them away from flames, hot plates and soldering irons.
What safety precautions apply to neodymium discs?
Prevent them from snapping together, which pinches skin and chips the magnets. Keep them away from young children, as swallowing more than one can cause serious injury, and away from pacemakers and electronic devices.
How should neodymium discs be stored?
Store them stacked with plastic or card spacers in a labelled box, away from other magnets, steel objects and electronic equipment. Spacers make it easy to slide one disc off the stack.
Last Updated: October 2026










Reviews
There are no reviews yet.