Quick Answer: The Light Barrier is a photoelectric gate: a light source shines across a gap onto a light sensor, and the instant an object interrupts the beam an electrical signal starts or stops a timer. Physics labs use a light barrier, also called a photogate, to time moving trolleys, falling objects and pendulums far more precisely than a hand-operated stopwatch.
How a Photogate Works
One arm of the gate carries a light source, often an infrared LED, and the other a sensor such as a phototransistor. While the beam reaches the sensor, its output stays in one state; when an object enters the gap and blocks the beam, the output switches. A timer, counter or data logger connected to the gate records the moment of each change, so time intervals are measured electronically without any human reaction time.
Timing Modes
In gate mode the timer measures how long the beam is blocked. If a card of known width on a trolley passes through, its speed is the card width divided by that time. With two gates a known distance apart, the timer measures the interval between the object passing the first and the second, giving average speed; combined with speeds at each gate, it gives acceleration. In pendulum mode the timer counts successive interruptions to measure the period. Which modes are available depends on the timer used.
Typical Experiments
Photogates are used on an air track for speed, acceleration and collision experiments, for Newton’s second law with trolleys, for free fall, where a ball or a striped card is dropped through one or two gates, and for timing pendulums and oscillating springs. The connector, supply requirements, sensor type and timer compatibility of this unit should be confirmed at enquiry so it can be matched with existing equipment.
Applications
- Measuring the speed of trolleys and gliders with an interrupt card
- Finding acceleration with two gates or a double card
- Measuring the acceleration due to gravity in free fall
- Timing pendulum and spring oscillations
Specifications
| Type | Photoelectric light gate (photogate) |
| Senses | Interruption of a light beam across its gap |
| Output | Signal to start or stop a timer, counter or data logger |
| Typical experiments | Speed, acceleration, free fall and pendulum timing |
| Connector, supply, sensor type and timer compatibility | Confirm at enquiry |
Care & Handling
- Mount the light barrier rigidly so the beam crosses the path of the object at the same point every run.
- Keep the emitter and sensor windows clean and free of dust.
- Avoid direct sunlight or strong lamps shining into the sensor.
- Do not pull the cable to disconnect it; hold the plug.
Why Choose LabEquip
Schools and colleges buy photogates to bring precise electronic timing to mechanics practicals that used to rely on stopwatches. LabEquip lists them with its physics lab equipment; a digital stop watch remains useful for slower events. Tell us which timer or logger you use through the contact page.
Frequently Asked Questions
How is speed measured with a single gate?
A card of known width attached to the moving object blocks the beam as it passes. The timer records how long the beam was blocked, and the card width divided by that time gives the speed.
How is acceleration measured?
Use two gates a known distance apart, or one gate with a card that has two separate sections. The speeds at two points and the time between them give the acceleration.
Why is a photogate more accurate than a stopwatch?
A person starting and stopping a watch adds a reaction time that varies from attempt to attempt. The gate switches electronically the instant the beam is broken, so short intervals can be measured reliably.
What equipment is needed with this gate?
A timer, counter or data logger that accepts its signal, and usually a stand or clamp to hold it in position. Its connector and supply should match the timer.
Why might readings be erratic in bright sunlight?
Strong sunlight contains infrared light that can reach the sensor even when the beam is blocked, so the gate may not switch cleanly. Shading the gate or moving the experiment away from windows solves the problem.
How is the acceleration due to gravity measured with a photogate?
A card with alternating clear and opaque bands, or a ball, is dropped through the gate. The timings of successive interruptions over known distances give the acceleration of the falling object.
Last Updated: October 2026










Reviews
There are no reviews yet.