Quick Answer: A single pan beam balance is a mechanical balance in which a load on one pan is balanced by sliding a poise along a graduated beam on the other side of the pivot, so the mass is read straight from the beam without loose weights. The single pan beam balance is used in school science and small workshops for straightforward weighing.
From Steelyard to Laboratory Balance
The single pan beam balance is a refined steelyard. A steelyard has a short arm carrying the load and a long graduated arm along which a counterpoise slides; the load is balanced when the counterpoise’s moment about the pivot equals the load’s moment. In the laboratory version the short arm carries a pan, the long arm is engraved with mass graduations, and a counterweight built into the beam balances the empty pan so that the poise reads zero.
Because the poise has a fixed mass and its position decides the reading, the scale along the beam is linear: doubling the distance from the pivot doubles the mass it balances. That gives a direct reading without the box of weights a double pan balance needs, which makes the single pan form quick to use once students learn to find the balance point.
Single Pan or Double Pan?
A double pan balance compares the load with standard weights placed on the opposite pan, so its accuracy depends on those weights and on equal arm lengths. The single pan form relies on the engraving of its beam and the mass of its poise, so it is faster, but its finest reading is limited by how finely the beam is divided. For general school weighing the single pan form is the convenient choice; where higher sensitivity is needed, a physical or analytical balance is used.
Specifications
| Type | Single pan mechanical beam balance |
| Principle | Moments, with a sliding poise on a graduated beam |
| Readout | Direct from the beam graduations |
| Power | Not required |
| Number of beams, capacity and graduation | Confirm at enquiry |
Where It Is Used
- Mass measurements in school physics, chemistry and biology practicals
- Teaching the principle of moments and how a steelyard works
- Weighing in workshops, small stores and kitchens without electricity
- Checking the mass of samples before and after drying or heating
Care & Handling
- Slide the poise to zero and confirm the balance point with the pan empty before each use.
- Keep the beam graduations clean so the poise slides and seats correctly.
- Place items gently in the centre of the pan; shock loads strain the pivot.
- Store in a dry place so the pivot and beam do not rust.
Why Choose LabEquip
This balance suits schools and small workshops that want direct-reading mechanical weighing without separate weights. Compare it with the multi-beam triple beam balance in our physics lab products category, and send quantities through the LabEquip contact page.
Frequently Asked Questions
How does a single pan beam balance work without weights?
A poise of fixed mass slides along the graduated beam. Its turning effect grows with its distance from the pivot, and at balance its position shows the mass of the load on the pan.
Is a single pan beam balance the same as a steelyard?
It uses the same principle. The laboratory version adds a pan, a counterweight to zero the empty pan and a finely engraved beam, so it is easier to read and more consistent than a traditional steelyard.
Why is the beam scale evenly spaced?
The moment of the poise equals its weight times its distance from the pivot, which rises in direct proportion to distance. Equal steps along the beam therefore correspond to equal steps of mass.
How do I know the balance point has been reached?
The pointer at the end of the beam comes to rest on, or swings evenly about, its zero mark. If it rests above or below, move the poise until it settles there.
Can it weigh objects heavier than the beam range?
Not directly. Loading beyond the beam range strains the pivot and no reading can be taken. Some models accept attachment weights that extend the range, which should be checked for the model supplied.
What limits the accuracy of the readings?
A level bench, a correct zero, clean pivots and reading the pointer at eye level matter most. The finest reading is limited by the smallest graduation on the beam.
Last Updated: October 2026










Reviews
There are no reviews yet.