Search

In Stock

FIXED 5 OHM RESISTOR

Nominal resistance value of 5 Ω with controlled tolerance, supporting precise electrical analysis

Low temperature-coefficient resistive element, maintaining stability during continuous laboratory use

₹170.00

Quick Answer: The fixed 5 ohm resistor is a single-value resistor used as the test resistor in Ohm’s law practicals. Its value draws currents of a few tenths of an ampere from cells, well suited to school ammeters, so a 5 ohm resistor gives clear, straight-line voltage–current graphs.

Verifying Ohm’s Law

Ohm’s law states that the current through a conductor at constant temperature is proportional to the voltage across it. The classic test uses a cell or low-voltage supply, a rheostat, an ammeter in series and a voltmeter across the resistor. Moving the rheostat gives a set of current readings, each with its voltage, and plotting voltage against current gives a straight line through the origin whose gradient is the resistance.

Five ohms suits this well. With one or two cells, currents of roughly 0.3 A to 0.6 A flow, comfortably within the range of school ammeters and large enough to read precisely. Higher-value resistors give smaller currents that need milliammeters, while lower values draw so much current that the resistor and cells warm during the experiment and the readings drift.

The experiment also introduces the idea of an ohmic conductor. Repeating it with a filament lamp in place of the resistor gives a curved graph, because the filament heats up, while the resistor’s graph stays straight as long as it stays cool. Plotting the two on one set of axes shows clearly what ohmic means.

Practicals

  • Verifying Ohm’s law by plotting voltage against current
  • Comparing an ohmic resistor with a filament lamp on the same axes
  • Determining resistance by the voltmeter-ammeter method and comparing it with a metre bridge result
  • Series and parallel combinations with other fixed values
  • A load for potential divider and power experiments

Care & Handling

  • Take each reading quickly and open the key between readings, so the resistor stays cool and its value stays constant.
  • Start with the rheostat at maximum so the first current is small, then increase it step by step.
  • Keep terminals tight and clean; corrosion adds resistance and makes readings drift.
  • Store the 5 ohm resistor with others in labelled trays so values are not confused.

Specifications

Component Fixed resistor
Nominal value 5 ohms, as titled
Current from one cell About 0.3 A by Ohm’s law, ignoring internal resistance
Typical use Test resistor in Ohm’s law practicals
Construction, tolerance and power rating Confirm at enquiry

Why Choose LabEquip

Schools buy fixed 5 ohm resistors as the standard test resistor for Ohm’s law, usually one per practical group. The fixed resistor 100 ohm suits milliamp work, and further values and resistance boxes are listed in LabEquip’s physics lab equipment. Send quantities through the contact page.

Frequently Asked Questions

Why is 5 ohms a good value for the Ohm’s law practical?

From one or two cells it draws currents of a few tenths of an ampere, which school ammeters read easily. The current is large enough for precise readings but small enough that the resistor does not heat much.

Why should the key be opened between readings?

Current heats the resistor, and its resistance changes slightly with temperature. Opening the key between readings keeps it cool, so the graph reflects the resistor and not a changing temperature.

What should the V against I graph look like?

A straight line through the origin, whose gradient equals the resistance. If the line curves at higher currents, the resistor is probably warming up, so reduce the current or take readings more quickly.

Why might the measured value differ from 5 ohms?

Every resistor has a tolerance, and meters have their own errors. Lead and contact resistances also add a little. A difference of a few percent is normal; a large difference suggests a fault in the circuit or a misread meter.

What is an ohmic conductor?

A conductor whose current is proportional to the voltage across it at constant temperature, giving a straight-line graph through the origin. Metal resistors behave this way; filament lamps, diodes and thermistors do not.

How much power does the resistor dissipate?

Power equals I²R or V²/R. At 0.4 A, a 5 ohm resistor dissipates 0.8 W. Check this against the resistor’s power rating and keep currents below the level that would make it hot.

Last Updated: October 2026

Reviews

There are no reviews yet.

Write a review

Back to Top
Select your currency
INR Indian rupee
Product has been added to your cart
Compare (0)