Quick Answer: The Water bath 100 °C – 16 tubes is a compact 16-tube water bath with a transparent tank and a front digital controller, as pictured; the title gives 100 °C, read here as its top temperature, so it covers boiling-water steps as well as lower incubations.
A Bath Sized Around One Set of Tubes
Many tube procedures need hot water for only a dozen or so samples. A 16-tube water bath is built around that job: the photo shows a transparent tank with tubes standing in a holder at the top and a control unit with a digital display on the front. With so little water to heat, it comes up to temperature quickly.
The 100 °C in the title matters. Ordinary water baths often stop short of boiling, yet several common tests need water at or near 100 °C: heating protein samples before gel electrophoresis, reducing-sugar tests and re-melting agar in tubes. At those temperatures water evaporates fast, so the level must be watched.
The clear tank lets you see the water level and the tubes without lifting them out. Tank material and the tube diameter accepted are not given in the title; tubes should fit the holder positions without forcing.
Specifications
| Type | Compact digital water bath for tubes |
| Tube positions | 16, as titled |
| Temperature | 100 °C stated in the title |
| Tank | Transparent, as pictured |
| Controls | Front digital controller, as pictured |
| Tube diameter and tank material | Confirm at enquiry |
Typical Tube Work
- Heating protein samples in loading buffer before gel electrophoresis
- Benedict’s test and other boiling-water tests in school and college practicals
- Melting agar deeps in tubes before pour plating
- Incubating tube reactions at lower set points, such as 37 °C
Care & Handling
- Top up the 16-tube water bath often when it runs near boiling, and never let the water fall below the heater.
- Loosen screw caps slightly before heating near boiling so pressure cannot build up in the tubes.
- Lift hot tubes with tongs or a heat-resistant rack, not with fingers.
- Clean the clear tank with mild detergent and a soft cloth to keep it transparent.
Why Choose LabEquip
Biology and biochemistry teaching labs buy compact tube baths so each group can run its own boiling-water step. LabEquip lists larger units such as the water bath with lid in General Lab Products, and confirms tube sizes through the contact page.
Frequently Asked Questions
Can this bath really reach boiling point?
The title gives 100 °C, the boiling point of water at sea level. At higher altitudes water boils at a lower temperature, so there the bath will boil a little below 100 °C.
Why do my tube caps pop open?
Air and vapour expand as tubes heat, raising the pressure inside. Loosen screw caps slightly, or use cap locks on snap-cap tubes, for steps near boiling.
How often should I top up the water?
Near boiling, evaporation is rapid, so check the level every few minutes during long runs and top up with hot water to avoid a sudden temperature drop.
Which tubes fit the 16 positions?
The title does not give the hole diameter. Measure your tubes and compare them with the holder before ordering, so they stand upright without forcing.
Can the bath be used at body temperature?
A bath that reaches 100 °C can normally be set lower as well, for example 37 °C for enzyme or serology work. Check the bottom of the range for incubations close to room temperature.
Why is the tank transparent?
A clear tank shows the water level and the tubes at a glance, which helps when water boils away quickly. Avoid scratching it with metal tools so it stays clear.
Last Updated: October 2026










Reviews
There are no reviews yet.