Quick Answer: The Vinyl or Fiberglass Pin for Clamp is a set of clamp sleeves that slide over the prongs (pins) of a laboratory clamp to cushion glassware. The listing photograph shows red, soft vinyl sleeves; fibreglass versions are the heat-resistant alternative for clamps used close to hot equipment.
What the Listing Actually Shows
The word “pin” in the title is misleading. The listing photograph shows two soft, red, dip-moulded vinyl sleeves, each a closed-ended pocket that slips over the jaw or prong of a clamp. The title appears to be translated from a catalogue term for clamp sleeves, and the page describes the item on that basis.
Bare metal clamp prongs grip glassware at a few hard points, which can chip a flask neck or let a smooth condenser slide. A sleeve on each prong spreads the pressure, adds grip and protects the metal from spills. Vinyl sleeves are soft and grippy but soften at higher temperatures, so they suit clamps at room temperature or mildly warm glassware. Fibreglass sleeves, woven from glass fibre, tolerate much higher temperatures and are used on clamps close to hotplates, heating mantles or hot condensers.
The title offers either material, and the listing does not say which is supplied by default or what prong sizes the sleeves fit. Replacement sleeves are commonly ordered when the original linings on finger clamps such as a three finger condenser clamp wear through.
Specifications
| Product type | Protective sleeves for clamp prongs |
| Material options | Vinyl or fibreglass, as titled |
| Shown in photo | Red vinyl sleeves |
| Purpose | Cushion and grip glassware, protect clamp metal |
| Sleeve size and quantity | Confirm at enquiry |
Applications
- Relining worn finger clamps used on flasks and condensers
- Adding grip to a clamp holding a smooth glass column
- Fitting fibreglass sleeves to clamps that sit close to a heat source
- Protecting clamp prongs from corrosive splashes
Care & Handling
- Choose fibreglass, not vinyl, for clamps near hot surfaces
- Replace sleeves that crack, harden or slide off the prong
- Wash vinyl sleeves with mild soap; avoid solvents that soften vinyl
- Handle fibreglass sleeves with gloves if the fibres become frayed
Why Choose LabEquip
Teaching labs order clamp sleeves in quantity each year as linings on shared clamps wear out. LabEquip can confirm sleeve sizes against your clamps and supply them from our general lab products range; contact us with the clamp type you use.
Frequently Asked Questions
What is the Vinyl or fiberglass pin for clamp?
It is a sleeve that fits over the prong of a laboratory clamp. The listing photograph shows red vinyl sleeves, despite the word pin in the title.
When should I choose fibreglass instead of vinyl?
Choose fibreglass for clamps near hot equipment, such as over a hotplate or on a hot condenser. Vinyl softens with heat and suits room-temperature clamping.
Why put sleeves on clamp prongs at all?
Sleeves spread the grip over a larger area, stop glass from slipping and reduce the risk of chipping flask necks and condensers.
How do I fit the sleeves?
Push each sleeve over a clean, dry prong until it sits fully. Warm water can make vinyl sleeves easier to fit.
Which clamp prong sizes do the sleeves fit?
The listing does not give sizes. Send us the clamp type or prong dimensions and we will confirm a matching sleeve.
How long do vinyl sleeves last?
It depends on use. Replace them when they crack, harden or no longer grip, which happens sooner with heat and solvent contact.
Last Updated: September 2026
Reviews
There are no reviews yet.