Quick Answer: The Eye Wash, 2 Ways is an emergency laboratory eye wash with two outlets, read here as one spray head for each eye, so that both eyes can be flushed with water at the same time after a chemical splash.
Why Two Outlets Matter
Chemical splashes rarely hit one eye alone, and an eye that is not rinsed keeps absorbing the chemical. A 2 way eye wash, read here as a twin-outlet unit, directs two soft streams upward so that they meet the eyes together while the person leans over the unit. The streams are meant to be gentle and aerated, not forceful, because the injured person has to hold the eyelids open in the flow for several minutes.
On eye wash fittings of this kind, water is usually started by pushing a paddle or flag and then stays on without being held, leaving both hands free to hold the eyelids apart, and dust covers on the heads flip off as the water flows. The listing does not state the mounting (deck, wall or pedestal) or the way this model is activated, so both need confirming before an order. If a unit for rinsing one eye is being considered, compare the Eye Wash, Single, which has one outlet.
An eye wash only helps if someone can reach it within seconds. Fit it close to where acids, alkalis and other corrosives are handled, on the same level, with nothing in the way and a clear sign above it. Train staff and students in its use, including taking out contact lenses if they come out easily, without stopping the rinse.
Where It Is Needed
- Chemistry labs where acids, alkalis and solvents are dispensed and diluted.
- Pharmaceutical quality-control and production areas handling corrosive reagents.
- Battery-charging rooms and workshops where electrolyte can splash.
- School and college preparation rooms where concentrated reagents are made up.
Specifications
| Item | Emergency eye wash with two outlets |
| Purpose | Flushing both eyes at once after a chemical splash |
| Flow | Gentle streams that users can keep their eyes open in |
| Water | Plumbed supply; lukewarm water is the usual recommendation |
| Mounting and activation | Confirm at enquiry |
Care & Handling
- Run the eye wash for a short time every week to flush out stagnant water and prove that it works.
- Keep the dust covers on the heads between uses so the outlets stay clean.
- Check that nothing is stored in front of the unit and that the sign above it can be seen.
- Record each test so that the routine can be audited.
Why Choose LabEquip
Pharmaceutical plants, college chemistry departments and schools upgrading lab safety buy twin-outlet eye washes for each area where corrosives are handled. LabEquip lists this unit in General Lab Products, and a lab safety poster near the station helps reinforce training.
Frequently Asked Questions
What does ‘2 Ways’ mean on this eye wash?
It is read here as two outlets, one for each eye, so both eyes are rinsed together. The listing does not define the term further, so confirm the head arrangement and mounting when you enquire.
How long should eyes be rinsed after a chemical splash?
Follow the first-aid section of the chemical’s safety data sheet. Many advise rinsing for at least 15 minutes with the eyelids held open, and then getting medical attention.
Why is the flow gentle rather than strong?
The injured person must keep the eyes open in the stream for several minutes. A strong jet hurts, makes people close their eyes and can drive particles further in, so eye washes use soft, aerated streams.
Where should an eye wash be installed?
Close to where corrosive chemicals are used, so it can be reached within seconds, on the same floor level, with a clear route and a visible sign. It should never be behind a door that might be locked.
Should contact lenses be removed during rinsing?
Yes, if they come out easily, but rinsing should start at once and not wait while someone tries to remove them. Carry on rinsing after they are out.
How often should the eye wash be tested?
A short weekly run is widely recommended to flush stagnant water from the pipe and confirm that the unit works, with a fuller inspection at the interval set by the lab’s safety policy.
Last Updated: September 2026










Reviews
There are no reviews yet.