Search

In Stock

Convection of Hot Currents

Convection des courants chauds, Optically Clear 3.3 Borosilicate Surface Facilitates the Evaluation of particle movement via dye-tracing or seeding, allowing for the empirical calculation of density-driven displacement.

High-Stability Integrated Support Base Ensures safe Application of open-flame or immersion heat sources during high-temperature demonstrations, adhering to vocational laboratory safety standards.

Specialized Filling Aperture Permits the Creation of varied fluid density gradients by introducing disparate liquid concentrations, advancing experimental design capabilities.

₹1,345.00

Quick Answer: This hot convection currents apparatus makes the circulation of heated fluid visible: when one part of the vessel is warmed, the heated water rises and cooler water sinks to replace it, and a small amount of dye shows the moving current. It is used to teach convection, density and the transport of heat in fluids.

Why Heated Fluid Circulates

Most fluids expand when warmed. A parcel of water heated low down in a vessel occupies slightly more volume than the same mass of cooler water, so its density falls and the surrounding cooler water, being heavier, pushes it upwards. As the warm water rises it carries thermal energy with it, cools near the top and sinks again on the cooler side. The result is a continuous loop of moving fluid called a convection current.

Convection happens only in liquids and gases, because their particles are free to move from place to place. In the common closed-loop design of this apparatus, heating one lower corner gives the current a fixed direction, so a dye crystal or a few drops of ink added at the top travel round the loop in a clear, predictable path.

Setting Up the Demonstration

Fill the apparatus completely with water, removing air bubbles, and let it stand until the water is still. Add a small dye crystal or a drop of food colouring at the opening, then warm the chosen corner gently with a small flame, a spirit burner or a hot water bath. The coloured stream soon leaves the heated region, climbs, travels across the top and returns down the opposite side. Moving the heat source to the other corner reverses the direction of flow, a quick check that the heating position, not chance, drives the circulation of the hot convection currents.

Specifications

Item Apparatus for demonstrating convection currents in a heated fluid
Principle Density difference between warm and cool fluid drives circulation
Indicator Dye crystal, ink or food colouring added to the water
Heat source Small burner or hot water bath applied at one point
Form, glass type and dimensions Confirm at enquiry

Care & Handling

  • Heat gently and at one point only; strong or uneven heating can crack glass
  • Let the apparatus cool before emptying and refilling it
  • Rinse out dye after use so stains do not build up on the glass
  • Support the apparatus in a clamp or stand rather than holding it by hand

Teaching Applications

  • Introducing convection as the transfer of heat by moving fluid
  • Showing how the heating position sets the direction of circulation
  • Modelling central heating, ocean currents and mantle convection
  • Comparing convection with conduction in the same lesson

Why Choose LabEquip

Teachers pick this apparatus because the coloured loop makes an invisible process obvious soon after heating starts. It works well after the thermal energy transfer case has introduced the three modes of heat transfer; more physics lab equipment is listed in the category, and LabEquip can confirm the form and glass used in the current model.

Frequently Asked Questions

What happens if the apparatus is heated at the top instead?

Very little circulation develops. Warm water is already at the top, so it stays there and heat spreads downwards only slowly by conduction. Heating from below is what drives a convection current.

Why does the coloured stream travel round the loop rather than spreading out?

The rising warm water and sinking cool water set up a steady circulation, and the dye is simply carried along with that flow. Without heating, the dye would spread only slowly by diffusion.

Can the apparatus show convection in air?

This type of apparatus is normally used with water. Convection in gases is usually shown with a separate chimney box, in which smoke from a smouldering taper is drawn towards a candle flame and carried up a chimney.

Where does convection matter on a large scale?

Ocean currents, weather systems and the slow movement of rock in the Earth’s mantle are all driven partly by density differences from uneven heating. The loop shows the same mechanism on the scale of a bench.

Why can the flow slow down during a long demonstration?

As the whole volume of water warms, the temperature difference between the heated side and the rest of the loop becomes smaller. The density difference falls with it, and so does the force driving the current.

What safety points apply?

Heat glass gently at first, never heat an empty or sealed apparatus, and keep the opening clear so expanding water can escape. Use dye in small amounts and wear eye protection when handling crystals.

Last Updated: October 2026

Reviews

There are no reviews yet.

Write a review

Back to Top
Select your currency
INR Indian rupee
Product has been added to your cart
Compare (0)