Quick Answer: A magnetic support for mechanics board work is a compact block with strong magnets on its base and a suspension point, so it grips a vertical steel board anywhere. The magnetic support for mechanics board experiments provides a fixed anchor from which springs, force meters, threads and pulleys can be hung.
What Actually Holds the Load
The magnets pull the magnetic support for the mechanics board straight into the steel surface. A load hanging from it pulls downward, parallel to the board, and that load is resisted not by the magnets directly but by friction between the support’s base and the board. The friction available is the coefficient of friction times the magnetic clamping force, so the support holds as long as the load stays below that limit.
This explains its behaviour. On clean, bare steel the clamping force and friction are high. On a painted, coated or dusty board the gap between magnet and steel grows, the clamping force falls, and the support slides at a lower load. A pull directed away from the board works directly against the magnets and is the easiest way to detach it.
Building Experiments from a Fixed Point
Almost every vertical-board experiment starts from a fixed suspension point. Hang a spring from the support to study extension, a thread and bob for a pendulum, or a force meter to measure the tension in a string. Two supports set at the same height make a horizontal bar for parallel springs or a hanging beam.
Because the support can be moved in seconds, the same board can be rearranged for the next group without tools.
Specifications
| Product | Magnetic anchor for vertical mechanics boards |
| Grip | Strong permanent magnets on the base |
| Attachment | Suspension point for hooks, loops and threads |
| Used with | Springs, force meters, pendulums, pulleys |
| Maximum load on a given board | Confirm at enquiry |
Uses on the Board
- Hanging springs for Hooke’s law work on a vertical board
- Suspending a pendulum or plumb line
- Anchoring force meters in equilibrium experiments
- Providing two level fixing points for parallel springs or beams
Care & Handling
- Tip the support off by one edge rather than dragging it across the board
- Keep two supports apart; strong magnets snap together hard and can pinch fingers
- Keep the base clean so grit does not reduce the grip or scratch the board
- Store away from compasses, magnetic cards and electronic devices
Why Choose LabEquip
Schools and colleges equipping metal boards for whole-class mechanics buy magnetic supports in quantity, as nearly every arrangement needs at least one. LabEquip can supply them with the 600 x 400 mm dry-erase metal panel and further physics lab equipment; contact LabEquip with your board count.
Frequently Asked Questions
What holds the support in place when a load hangs from it?
Friction between its base and the board. The magnets press the base against the steel, and that clamping force allows a friction force large enough to carry the hanging load.
Why does it hold better on some boards than others?
The grip depends on how close the magnets can get to bare steel and how thick the steel is. Paint, plastic coatings, dust and thin sheet metal all reduce the clamping force and so the friction.
What can be hung from it?
Springs, force meters, threads for pendulums, pulleys on hooks and light beams. Anything that needs a fixed suspension point on a vertical board.
How should it be removed from the board?
Tilt it away from the board from one edge so the magnets lift off gradually. Dragging it sideways scratches the surface and pulling straight off needs the full magnetic force.
Is it safe to keep near other equipment?
Keep it away from compasses, magnetic cards, phones and other magnets. Two supports allowed to snap together can pinch fingers and chip the magnets.
How much load can it take?
That depends on the board as well as the support, and the rated figure can be confirmed at enquiry. To test on your own board, add load gradually with a force meter until the support begins to slide.
Last Updated: October 2026










Reviews
There are no reviews yet.