Quick Answer: The Blue Connecting Wires with Side-Opening Terminals are insulated patch leads with plug terminals at each end, where each plug has an opening at its side or rear so another lead can be plugged into it. These blue connecting wires let students stack two leads at one socket when building circuits with meters, supplies and components.
What the Side Opening Is For
In a circuit, several connections often meet at one point: the positive terminal of a supply may feed both a resistor and a voltmeter, for example. A plain plug fills the socket, leaving nowhere for the second lead. A plug with a side-opening terminal accepts another plug into its own body, so leads can be stacked on one socket and every connection still makes metal-to-metal contact. This is the usual meaning of the term; plug size and lead length should be confirmed before ordering to match the sockets on existing meters and boards.
Stacking keeps circuits tidy. A voltmeter can be added across a component after the main loop is built, simply by plugging its leads into the backs of the plugs already in place, without dismantling anything.
Why Use a Colour Set
Lead colour carries no electrical difference, but it makes circuits readable. Many teachers use red for connections to the positive side of the supply and black for the return, then a third colour such as blue for the meter branch or for a second loop. When students check their wiring against a diagram, a consistent colour scheme shows at a glance which lead goes where, and it makes faults far easier to find.
Circuits and Practicals
- Building series and parallel circuits on a senior circuit board or similar socket board
- Adding a voltmeter across a component without breaking the main loop
- Wiring Ohm’s law, potentiometer and meter bridge experiments
- Colour-coding a meter branch or a second circuit on the same bench
Specifications
| Colour | Blue |
| Terminals | Plug at each end with a side opening for stacking a second lead |
| Use | Low-voltage circuit wiring in teaching laboratories |
| Pairs with | Meters, power supplies, circuit boards, resistance boxes |
| Plug size, lead length and pack quantity | Confirm at enquiry |
Care & Handling
- Pull leads out by the plug body, never by the cable, to avoid breaking the conductor inside.
- Test suspect leads for continuity with a multimeter; a broken core can hide inside intact insulation.
- Coil leads loosely and hang them on a rack; tight knots stress the cable where it joins the plug.
- Use these leads only for low-voltage teaching circuits, never for mains wiring.
Why Choose LabEquip
Physics laboratories reorder connecting leads every year, because leads wear out faster than meters, and a colour set makes class circuits easier to check. LabEquip lists these blue connecting wires among its physics equipment, and lengths and pack quantities for a full laboratory can be arranged through the contact page.
Frequently Asked Questions
What does a side-opening terminal do?
It lets a second plug be pushed into the body of the first, so two or more leads can share one socket. That is how a voltmeter can be connected to a point already used by the main circuit.
Does the colour of a lead affect the circuit?
No. All leads of the same construction conduct the same way. Colour is a convention that makes circuits easier to read and check, for example blue for a meter branch.
How can I find a lead with a broken wire inside?
Set a multimeter to its continuity or lowest resistance range and touch the probes to the two plugs while flexing the cable. A reading that drops out or jumps shows a broken conductor.
Can these leads be used with mains equipment?
No. They are made for low-voltage teaching circuits. Mains-connected equipment needs its own fully shrouded leads and must never be wired with open patch leads.
How many leads does a typical bench need?
A simple series and parallel practical uses about six to eight leads, while a potentiometer or meter bridge set-up may use ten or more. Plan for spares, since leads are lost and worn faster than meters.
Why do some plugs become loose in sockets?
The sprung contacts on the plug lose tension with use. Gently opening the springs can restore grip, but a loose plug gives intermittent contact and is better replaced.
Last Updated: October 2026










Reviews
There are no reviews yet.