Quick Answer: The Ticker Tape Timer, Regular Type is a motion-recording timer that prints a row of dots on a paper tape as a moving object pulls the tape through it, so that equal time intervals appear as dot spacings. Distances between dots then give displacement, velocity and acceleration in mechanics practicals.
Recording Motion on a Strip of Paper
A ticker timer turns a fleeting motion into a permanent record. A striker vibrates at a steady rate and presses a carbon disc against the tape, leaving a dot each time. Where the object moves slowly the dots crowd together; where it speeds up they spread out. Once the time between dots is known, a ruler is enough to extract speeds and accelerations.
The title describes this as the regular type, alongside a separately listed AC ticker tape timer. The listing does not say how the regular type is powered or driven, so its supply voltage, and whether it runs on AC or uses a DC make-and-break contact, should be settled before ordering. This matters: an AC timer’s dot rate is fixed by the supply frequency, whereas a DC contact timer’s rate depends on voltage and adjustment and has to be measured.
A simple way to find the dot interval of any ticker timer is to pull a length of tape through it steadily for a timed period, say ten seconds by stopwatch, and count the dots. Dividing the time by the number of intervals gives the value to use in calculations. Run a trolley down an adjustable inclined plane at two or three slopes and the tapes show directly how acceleration changes with the angle.
Mechanics Practicals
- Telling uniform motion from uniform acceleration on a runway
- Measuring acceleration at different slopes of an inclined plane
- Comparing momentum before and after trolley collisions from the change in dot spacing
- Producing tape charts that link a real motion to its velocity-time graph
Specifications
| Type | Ticker timer, regular pattern |
| Records | Dots on paper tape at a steady rate |
| Used with | Ticker tape, carbon discs, trolley and runway |
| Data obtained | Displacement, velocity and acceleration from dot spacing |
| Power supply and drive type | Confirm at enquiry |
Care & Handling
- Check the rated supply marked on the timer before connecting it, and use a laboratory power supply.
- Thread the tape beneath the carbon disc and keep it aligned with the direction of pull.
- Measure the dot interval at the start of each session if the timer has an adjustable contact.
- Store analysed tapes flat and labelled with the trial details.
Why Choose LabEquip
Physics teachers equipping mechanics practicals buy ticker timers together with runways, trolleys and tape so that each group records its own motion. LabEquip lists this regular type in the General Lab Products range; confirm the supply type and quantity through the contact page.
Frequently Asked Questions
What is the difference between the regular type and the AC type?
The AC type vibrates in step with an alternating supply, so its dot rate follows the supply frequency. The title does not say how the regular type is driven; if it uses a DC contact, its rate depends on voltage and adjustment and should be measured each session.
How do I measure the time between dots?
Pull tape through the running timer for a timed period, count the dot intervals and divide the time by that count. Repeat once or twice and average, then use the result in place of an assumed value in later calculations.
How is acceleration found from a tape?
Find the average velocity over two successive equal sections of tape, then divide the change in velocity by the time between the midpoints of those sections. A steady increase from section to section indicates uniform acceleration.
Why is the runway tilted slightly?
Friction and the drag of the tape slow a trolley on a level runway. Raising one end just enough that the trolley runs at steady speed after a push compensates for friction, so any extra force produces a clean acceleration.
What do evenly spaced dots mean?
Equal spacing means equal distances in equal times, so the object moved at constant velocity. Spacing that grows steadily shows acceleration, and spacing that shrinks shows deceleration.
Can the timer be used for collisions?
Yes. Attach the tape to one trolley and let it collide with another. The change in dot spacing before and after the collision gives the velocities needed to compare momentum.
Last Updated: September 2026










Reviews
There are no reviews yet.