Quick Answer: The Circuit Board, Senior is a circuit-building board for higher secondary students, used when circuits have to be measured as well as built. A senior circuit board supports practicals on current and potential difference, Ohm’s law, resistors in series and parallel, and Kirchhoff’s rules.
From Building Circuits to Measuring Them
At senior level the questions change. It is no longer enough that the lamp lights; students need to know how much current flows, how the potential difference divides, and whether the results agree with theory. A senior board provides a fixed layout in which an ammeter and a voltmeter can be placed at the right points and a variable resistance can set the current, so that a full set of readings fits into one lesson.
Typical investigations include plotting potential difference against current for a resistor to verify Ohm’s law, comparing that straight line with the curve given by a filament lamp, and confirming that the currents entering a junction equal those leaving it (Kirchhoff’s first rule) and that the potential differences around a loop add up to the supply voltage (the second rule).
The listing does not give the component list or layout, so check the contents and the meters expected against your syllabus. Students with a digital multimeter can take every reading from one instrument by switching between current and voltage.
Specifications
| Type | Circuit board for senior secondary practicals |
| Use | Measured circuits with meters in series and parallel |
| Topics | Ohm’s law, I-V graphs, resistor combinations, Kirchhoff’s rules |
| Power | Low-voltage DC supply or cells |
| Components and layout | Confirm at enquiry |
Practicals
- Verifying Ohm’s law from a graph of potential difference against current
- Comparing the I-V characteristic of a fixed resistor with that of a filament lamp
- Checking the rules for resistors in series and in parallel
- Testing Kirchhoff’s current and voltage rules in a circuit with branches
Care & Handling
- Connect ammeters in series and voltmeters in parallel, and check the circuit before switching on.
- Start with any variable resistance at its maximum so that the first current is small.
- Switch off between readings so that resistors and cells do not heat up.
- Keep the board dry and store meters separately in their cases.
Why Choose LabEquip
Higher secondary physics teachers and junior colleges buy this board so that every group follows the same circuit layout in practicals. It sits in LabEquip’s Physics Equipments range next to the junior circuit board for earlier classes, and the contents can be confirmed through our contact page.
Frequently Asked Questions
How should meters be connected on the senior circuit board?
An ammeter goes in series, so the current passes through it, and a voltmeter goes in parallel across the component being tested. An ammeter connected in parallel can short the supply, so check the circuit before switching on.
How is Ohm’s law verified with this board?
Change the current through a fixed resistor in several steps, recording current and potential difference each time. A graph of potential difference against current that is a straight line through the origin shows that the resistance is constant.
Why does a filament lamp not give a straight line?
As the current rises the filament heats up and its resistance increases, so the I-V graph curves. Comparing it with a fixed resistor shows that Ohm’s law holds only while the temperature stays constant.
What are Kirchhoff’s rules and can they be tested here?
The first rule says the total current into a junction equals the total current out. The second says the potential differences around any closed loop add up to the supply voltage. Both are checked by measuring at several points in a branched circuit.
Why switch off between readings?
Current heats resistors and wires, and their resistance changes as they warm. Switching off between readings keeps temperatures steady, saves the cells and gives more consistent results.
Is the senior board suitable for college laboratories?
It suits introductory college work on direct-current circuits. Precise resistance measurement at degree level normally moves on to bridges and potentiometers, such as the metre bridge and the post office box.
Last Updated: October 2026










Reviews
There are no reviews yet.