Quick Answer: The Tripod Stand, Wire Type, MS is a light heating tripod bent from mild steel rod, with a round wire ring on top and three wire legs, used to hold a wire gauze and beaker or a pipeclay triangle over a Bunsen burner. It is the simplest and lightest of the tripod types.
The Lightweight Wire Tripod
A wire tripod stand has almost nothing to it: a ring of round mild steel rod and three rod legs joined to it. That simplicity is its advantage. It is light enough to carry in a tray of class apparatus, it stacks, and it bends rather than breaks if dropped. For the small beakers and dishes typical of school practicals, it carries the load comfortably.
The light weight is also its limit. With little mass low down, a wire tripod can tip if a heavy vessel is placed off-centre or if the burner tube is tugged. Keep the gauze centred, use moderate volumes, and move to a heavy cast iron tripod for water baths and large flasks. The round rod ring touches the gauze only along a thin line, so gauzes must be larger than the ring to sit securely.
Mild steel wire is usually plated or painted against rust; the finish on this item is not stated in the title. Where the coating wears through near the flame, keep the stand dry between lessons.
Care & Handling
- Centre the gauze and vessel so the weight falls well inside the legs.
- Straighten bent legs before use; a tripod that rocks is a tipping hazard.
- Store the stands dry and nested to save space.
- Do not load a wire tripod with a full water bath or large flask; use a heavier stand.
Specifications
| Type | Wire type heating tripod |
| Material | Mild steel rod (MS) |
| Top | Round wire ring |
| Legs | Three rod legs |
| Holds | Wire gauze, pipeclay triangle |
| Finish, ring diameter and height | Confirm at enquiry |
Applications
- Heating small beakers of water or solutions on gauze in lower-secondary science
- Crucible heating on a pipeclay triangle for small samples
- Class sets carried between rooms or used in temporary labs
- Heating over spirit lamps in schools without a gas supply
Why Choose LabEquip
Wire tripods are bought in large numbers by schools setting up class practicals, where every group needs a heating station that is light and easy to store. LabEquip lists this stand in its General Lab Products range; contact us with the number of groups you are equipping.
Frequently Asked Questions
How stable is a wire tripod compared with a cast iron tripod?
Less stable. It is light and carries its load high up, so an off-centre vessel or a tug on the burner tube can tip it. For heavy vessels or water baths, a cast iron or heavier stand is safer.
Why does the gauze need to be larger than the ring?
A round wire ring touches the gauze only along a thin line. A gauze that overhangs the ring on all sides sits flat and cannot slip through or tilt.
Can students carry wire tripods safely?
Yes, when cold, as they are light enough to carry in a tray. After heating, leave them to cool in place, because the ring and upper legs stay hot for several minutes.
What happens if a wire tripod is dropped?
Mild steel wire bends rather than cracking. Straighten the leg on a flat surface and check that the tripod stands level without rocking before using it again.
Can it be used with a spirit lamp?
Yes. Many schools without mains gas heat with spirit lamps. Because the flame is short, check that its tip reaches close to the gauze, and raise the lamp on a block if it does not.
What is a pipeclay triangle used for on the tripod?
It rests across the ring and holds a crucible so its base sits in the flame. It is used for strong heating of solids, such as burning magnesium ribbon or heating hydrated copper sulfate.
Last Updated: September 2026










Reviews
There are no reviews yet.