Quick Answer: The wedge-shaped capillary vessel is made of two transparent plates set at a very small angle, so the gap between them narrows steadily to almost nothing along one edge. When the wedge-shaped capillary vessel stands in a coloured liquid, the liquid climbs highest where the gap is narrowest and its edge traces a smooth curve that demonstrates Jurin’s law of capillary rise.
Why the Liquid Edge Forms a Hyperbola
Between two parallel plates a distance d apart, a wetting liquid rises to a height h = 2γcosθ/(ρgd), where γ is the surface tension, θ the contact angle, ρ the density and g the acceleration due to gravity. In the wedge-shaped capillary vessel the gap is not constant: it grows in proportion to the distance x from the line where the plates meet, so d = αx for a small wedge angle α.
Substituting gives h = 2γcosθ/(ρgαx), so the product h × x is the same everywhere along the liquid edge. A curve with that property is a rectangular hyperbola. The vessel therefore shows in one picture what a set of separate capillary tubes shows only at a few points: height falls smoothly as the gap widens.
Testing the Curve
Photograph the wedge-shaped capillary vessel square-on with a ruler in the frame, or read heights through the front plate against a scale. Measure h at eight to ten distances x from the closed edge, then check whether h × x stays roughly constant, or plot h against 1/x and look for a straight line.
Very close to the closed edge the gap is so fine that the rise is limited by how evenly the plates meet, so readings there are usually left out. Further out, the agreement with the hyperbola is a convincing confirmation of Jurin’s law.
Applications
- Showing capillary rise varying continuously with gap width
- Verifying that height times distance from the closed edge is constant
- Comparing water with ethanol or soapy water to show the effect of surface tension
- Linking capillary rise to water movement in soil, paper and plant tissue
Specifications
| Product | Wedge-shaped capillarity vessel |
| Construction | Two transparent plates meeting at a small angle |
| Effect shown | Capillary rise along a hyperbolic curve |
| Law tested | Jurin’s law, height inversely proportional to gap width |
| Plate material and wedge angle | Confirm at enquiry |
Care & Handling
- Clean the plates with warm detergent solution, rinse with distilled water and allow to drain dry
- Avoid touching the inner faces; skin oil stops water wetting the surface and spoils the curve
- Use food colouring sparingly and rinse straight after use so the plates do not stain
- Store upright in a dust-free place so nothing enters the narrow gap
Why Choose LabEquip
Teachers who want students to see a law rather than just test points buy the wedge-shaped vessel alongside a capillarity study device with separate tubes. LabEquip supplies both within its physics lab equipment range; enquire with LabEquip for quantities.
Frequently Asked Questions
Why does the liquid edge form a curve?
The gap between the plates widens steadily away from the closed edge. Capillary rise is inversely proportional to the gap, so the height falls smoothly as the gap grows, tracing a hyperbola.
How can the hyperbola be checked?
Measure the liquid height at several distances from the closed edge and multiply each height by its distance. If the products are close to one value, or a graph of height against one over distance is straight, the curve is a hyperbola.
How does a slit compare with a capillary tube?
A slit between parallel plates raises a liquid to the same height as a round tube whose radius equals the slit width. For the same width, a tube has twice as much wetted wall per unit of liquid as a slit, so a slit only matches a tube twice as wide.
Which liquids give the clearest curve?
Water with a little food colouring gives the clearest curve. Ethanol rises less because its surface tension is lower, and a drop of detergent in water also lowers the curve, which makes a good comparison.
Why does the curve sometimes look uneven?
Grease, dust or dried residue on the plates changes how well the liquid wets the surface, so it climbs unevenly. Thorough cleaning with detergent and a distilled-water rinse usually restores a smooth curve.
Can the curve be analysed from a photograph?
Yes. Include a ruler in the picture, take it square to the plates and measure heights and distances on screen. This is quicker and less prone to parallax than reading through the plate by eye.
Last Updated: October 2026










Reviews
There are no reviews yet.